Sensoray 335 Manuel d'utilisateur télécharger pdf (Page 11)

LEDs

The LED D1 and D2 are used for indicating the status of PCMCIA PC-cards:

D1 (Red) -- for Slot#-Top

D2 (Red) -- for Slot#-Bottom

For both D2 and D2:

On -- card inserted and active

Off -- no card inserted or inactive

The LED D5 is used for indicating the status of Power-Ok:

On -- Power is good

Off -- Power is not good or not on the board

Configuration DIP Switches

Slot# selection, SW1

The DIP switch SW1 is used for selecting the PC/104+ module slot number. Refer to the table blow

for slot number selection.

SW1-1 SW1-2 Module Slot #

on on Slot#0

off on Slot#1

on off Slot#2

off off Slot#3

Interrupt routing selection, SW2

The DIP switch SW2 is used for selecting an interrupt routing for the PC card controller TI PCI-

1520 to submit the interrupt. Refer to the table blow for the routing selection.

SW2-1 SW2-2 SW2-3 SW2-3 Interrupt Routing

on off off off INTA#

off on off off INTB#

off off on off INTC#

off off off on INTD#

1 2 ... 6 7 8 9 10 11 12

Pas de commentaire

Sensoray 335 Manuel d'utilisateur Page 11