Sensoray 512 DOS Manuel d'utilisateur télécharger pdf (Page 8)

4.2 Connectors

The header J2 carries all the I/O signals. The pinout is given in Table 2.

Pin Function Pin Function

1 Digital I/O 2 2 +5V

3 Digital I/O 1 4 Digital ground

5 Digital I/O 0 6 Digital ground

7 N/A 8 N/A

9 N/A 10 N/A

11 SVideo out – Y 12 Video ground

13 SVideo out – C 14 Video ground

15 Composite video out 16 Video ground

17 Composite video in 4 / SVideo 1 – C 18 Video ground

19 Composite video in 3 / SVideo 2 – C 20 Video ground

21 Composite video in 2 / SVideo 1 – Y 22 Video ground

23 Composite video in 1 / SVideo 2 – Y 24 Video ground

Table 2 Header J1 Pinout

The BNC connector (if installed) are for composite video. J1 is composite video out and J3 is composite

video in 1. The center pin is the signal and the out shell is video ground.

5. DOS Driver

Using the DOS COPY command, copy the files from the distribution diskette to your system. It is a good

idea to create a subdirectory for the files. For example,

MD C:\X12DOS

COPY A:\DOS\*.* C:\X12DOS

Before an application can use the driver the TSR (terminate and stay resident) executable X12TSR.EXE

This is used to setup bit rate, resolution, etc.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Pas de commentaire

Sensoray 512 DOS Manuel d'utilisateur Page 8