Sensoray 7429 Manuel d'utilisateur télécharger pdf (Page 11)

HARDWARE CONFIGURATION

DEFAULTS

The 7429 requires installation of programming shunts to select various options such as

I/O port addresses, interrupts, and individual channel filters. This chapter describes

these configuration options.

After configuring the option shunts, the sensor coprocessor may be installed in you

STDbus backplane and programmed as explained in the next chapter.

Defaults as shipped from the factory

Command/Data port B2H

Status port B3H

I/O space primary

Data available interrupt disabled

Alarm interrupt disabled

STDbus interrupt enable disabled

Individual channel filters disabled

I/O SPACE

Two separate I/O spaces exist on the STD bus: primary and expanded. Option jumper

E21 selects which I/O space the 7429 board will reside in.

Install E21 to map the board into primary I/O space, or remove E21 to map the board

into expanded I/O space. E21 is factory set to map the board into primary space.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 47 48

Pas de commentaire

Sensoray 7429 Manuel d'utilisateur Page 11